Installing The Hot-Swap Scsi Hard Disk Drive Bay Upgrade Kit - NEC EXPRESS5800/120Md Series User Manual

Installing the Hot-Swap SCSI Hard Disk Drive
Bay Upgrade Kit
This subsection describes how to install the optional Hot-Swap SCSI Hard Disk
Drive Bay Upgrade Kit.
Before doing the procedures in this subsection, make sure
that your system is powered off and unplug all AC power
cords. Failure to disconnect power before opening your
system can result in personal injury and equipment damage.
All voltage is removed only when the power cords are
unplugged.
Install the Hot-Swap SCSI Hard Disk Drive Bay Upgrade Kit as follows:
1. Observe the safety and ESD precautions listed at the beginning of this
chapter.
2. If tower-based system, remove the front door of the cabinet. See Removing
the Front Door of the Tower Cabinet earlier in this chapter.
3. If rack-mounted system, remove the six screws securing the rack front panel
to the chassis (see Figure 4-8) and remove the panel.
4. The drive cover located on the left-hand side of the chassis is secured from
its front edge with a screw (see Figure 4-37). Remove the screw and pull the
cover slightly towards the front of the chassis until its hooks disengage from
the chassis. Remove the cover by pulling it away from the side of the chassis
and set it aside for reattaching later.
4-46 Upgrading Your System
! WARNING
Figure 4-37. Removing the Drive Cover