Example 2 - Huawei Quidway S3100 Series Operation Manual

Operation Manual – IGMP Snooping
Quidway S3100 Series Ethernet Switches
II. Network diagram
Router
Switch
Figure 1-3 Network diagram for IGMP Snooping configuration
III. Configuration procedure
# Enable IGMP Snooping in system view.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] igmp-snooping enable
# Enable IGMP Snooping on VLAN 10 where no Layer 3 multicast protocol is enabled.
[Quidway] vlan 10
[Quidway-vlan10] igmp-snooping enable

1.4.2 Example 2

Configure multicast VLAN on Layer 2 and Layer 3 switches.
I. Network requirements
Table 1-11 describes the network devices involved in this example and the
configurations you should make on them.
Table 1-11 Network devices and their configurations
Switch A
Internet
Multicast
Device
Layer 3 switch
Huawei Technologies Proprietary
1-11
Chapter 1 IGMP Snooping Configuration
Description
The interface IP address of VLAN 20 is
168.10.1.1. The Ethernet1/0/1 port is connected
to the workstation and belongs to VLAN 20.
VLAN 10 is the multicast VLAN.
The Ethernet1/0/10 port is connected to Switch
B.