Chapter 3 Logging In Through Telnet; Introduction; Common Configuration - Huawei Quidway S3100 Series Operation Manual

Operation Manual – Login
Quidway S3100 Series Ethernet Switches

Chapter 3 Logging in through Telnet

3.1 Introduction

You can telnet to a remote switch to manage and maintain the switch. To achieve this,
you need to configure both the switch and the Telnet terminal properly.
Table 3-1 Requirements for Telnet to a switch
Switch
Telnet terminal

3.1.1 Common Configuration

Table 3-2 lists the common Telnet configuration.
Table 3-2 Common Telnet configuration
VTY
interface
configuration
Item
The management VLAN of the switch is created and the
route between the switch and the Telnet terminal is
available. (Refer to the Management VLAN Configuration
module for more.)
The authentication mode and other settings are
configured. Refer to Table 3-2 and Table 3-3.
Telnet is running.
The IP address of the management VLAN of the switch is
available.
Configuration
Configure
command
available to users
lo gging into
user
VTY user interface
Configure
protocols the user
interface supports
Huawei Technologies Proprietary
Chapter 3 Logging in through Telnet
Requirement
the
Optional
level
By default, commands of level 0 is available
the
to users logging into a VTY user interface.
Optional
the
By default, Telnet and SSH protocol are
supported.
3-1
Description