Configuration Example - Huawei Quidway S3100 Series Operation Manual

Operation Manual – Management VLAN
Quidway S3100 Series Ethernet Switches

2.3.3 Configuration Example

I. Network requirements
To manage the switch QuidwayA remotely, which operates as a DHCP client, through
Telnet, The following are required:
QuidwayA has an IP address that is obtained through DHCP
The route between QuidwayA and the remote console is reachable
To achieve this, you need to perform the following configuration for the switch:
Configuring the management VLAN interface to obtain an IP address through
DHCP
Configuring a default route
II. Configuration procedures
# Enter system view.
<QuidwayA> system-view
# Create VLAN 10 and configure VLAN 10 to be the management VLAN.
[QuidwayA] vlan 10
[QuidwayA-vlan10] quit
[QuidwayA] management-vlan 10
# Create VLAN 10 interface and enter VLAN interface view.
[QuidwayA] interface vlan-interface 10
# Configure the management VLAN interface to obtain an IP address through DHCP.
[QuidwayA-Vlan-interface10] ip address dhcp-alloc
[QuidwayA-Vlan-interface10] quit
# Configure a default route.
[QuidwayA] ip route-static 0.0.0.0 0.0.0.0 1.1.1.2
Huawei Technologies Proprietary
2-5
Chapter 2 DHCP/BOOTP Client Configuration