Chapter 2 Routing Port Join To Multicast Group Configuration; Routing Port Join To Multicast Group Configuration - Huawei Quidway S3100 Series Operation Manual

Operation Manual – IGMP Snooping
Quidway S3100 Series Ethernet Switches
Chapter 2 Routing Port Join to Multicast Group

2.1 Routing Port Join to Multicast Group Configuration

2.1.1 Introduction
Normally, an IGMP host responds to IGMP query messages of the multicast router. In
case of response failure, the multicast router may consider that there is no multicast
member on this network segment and cancel the corresponding path.
To avoid such a problem, you can configure an interface of the switch as a multicast
group member. When the interface receives IGMP query packets, it will respond, thus
ensuring that the network segment of the interface can normally receive multicast
packets.
2.1.2 Configuring Routing Port to Join to Multicast Group
Table 2-1 Configure routing port to join to multicast group
Operation
Enter system view
Enter Ethernet port
view
Configure a routing
port to join to the
specified multicast
group
By default, a routing port doest not join any multicast group. Note that the Ethernet port
must belong to the VLAN; otherwise, your configuration cannot take effect.
Configuration
Command
system-view
interface
interface-number
igmp host-join group-address vlan
vlan-id
Huawei Technologies Proprietary
2-1
Chapter 2 Routing Port Join to Multicast
Group Configuration
Description
—
interface-type
—
Optional
group-address is the
IP address
multicast group.
of a