Configuration Example - Huawei Quidway S3100 Series Operation Manual

Operation Manual – Login
Quidway S3100 Series Ethernet Switches

3.4.2 Configuration Example

I. Network requirements
Assume that you are a level 3 AUX user and want to perform the following configuration
for Telnet users logging into VTY 0:
Configure the name of the local user to be "guest".
Set the authentication password of the local user to 123456 (in plain text).
Set the service type of VTY users to Telnet.
Configure to authenticate users logging into VTY 0 in scheme mode.
The commands of level 2 are available to users logging into VTY 0.
Telnet protocol is supported in VTY 0.
The screen can contain up to 30 lines.
The history command buffer can store up to 20 commands.
The timeout time of VTY 0 is 6 minutes.
II. Network diagram
Figure 3-3 Network diagram for Telnet configuration (with the authentication mode
being scheme)
III. Configuration procedure
# Enter system view.
<Quidway> system-view
# Create a local user named "guest" and enter local user view.
[Quidway] local-user guest
# Set the authentication password of the local user to 123456 (in plain text).
[Quidway-luser-guest] password simple 123456
# Set the service type to Telnet.
[Quidway-luser-guest] service-type telnet level 2
# Enter VTY 0 user interface view.
[Quidway] user-interface vty 0
RS-232 RS-232
Console cable Console cable
Huawei Technologies Proprietary
Chapter 3 Logging in through Telnet
Console port Console port
3-14