Configuring The Level Of A Specific Command In A Specific View; Cli Views - Huawei Quidway S3100 Series Operation Manual

Operation Manual – CLI
Quidway S3100 Series Ethernet Switches

1.2.2 Configuring the Level of a Specific Command in a Specific View

You can configure the level of a specific command in a specific view. Commands fall
into four command levels: visit, monitor, system, and manage, which are identified as 0,
1, 2, and 3 respectively. The administrator can change the command level a command
belongs to.
Table 1-3 lists the operations to configure the level of a specific command.
Table 1-3 Configure the level of a specific command in a specific view
Operation
Enter system view
Configure the level of
a specific command
in a specific view

1.2.3 CLI Views

CLI views are designed for different configuration tasks. They are interrelated. You will
enter user view once you log into a switch successfully, where you can perform
operations such as displaying operation status and statistical information. And by
executing the system-view command, you can enter system view, where you can
enter other views by executing the corresponding commands.
The following CLI views are provided:
User view
System view
Ethernet port view
VLAN view
VLAN interface view
LoopBack interface view
Local user view
User interface view
FTP client view
SFTP client view
MST region view
Cluster view
Public key view
Public key editing view
Basic ACL view
Advanced ACL view
RADIUS scheme view
Command
system-view
command-privilege
level level view view
command
Huawei Technologies Proprietary
1-3
Chapter 1 CLI Overview
Description
—
Required
Use this command with caution to
prevent inconvenience
maintenance and operation.
on