Configuration Example - Huawei Quidway S3100 Series Operation Manual

Operation Manual – Management VLAN
Quidway S3100 Series Ethernet Switches
Operation
Shut
management
VLAN interface
Bring
management
VLAN interface
Caution:
To configure the management VLAN of a switch operating as a cluster management
device to be a cluster management VLAN (using the management-vlan vlan-id
command) successfully, make sure the vlan-id argument provided in the
management-vlan vlan-id command is consistent with that of the management
VLAN.
Shutting down or bringing up a management VLAN interface has no effect on the
up/down status of the Ethernet ports in the management VLAN.
Note:
If the Stack function is enabled on the switch, the secondary devices of a stack will
repeatedly joint and leave the primary device after you use the shutdown command on
the management VLAN interface. This is normal and can be recovered after you use
the undo shutdown command on the management VLAN interface.

1.2.3 Configuration Example

I. Network requirements
The administrator wants to manage the switch QuidwayA remotely through Telnet. The
requirements are as follows: QuidwayA has an IP address, and the route between
QuidwayA and the remote console is reachable.
You need to configure the switch as follows:
Assigning an IP address to the management VLAN interface
Configuring a default route
down the
Shutdown
up the
undo shutdown
Huawei Technologies Proprietary
Chapter 1 Management VLAN Configuration
Command
1-3
Remark
Optional
By default, a management
VLAN interface is down if all
the Ethernet ports in the
management VLAN are down;
a management
interface is up if one or more
Ethernet ports in
management VLAN are up.
VLAN
the