Displaying Aaa&Radius Information - Huawei Quidway S3100 Series Operation Manual

Operation Manual – AAA&RADIUS
Quidway S3100 Series Ethernet Switches
Note:
The switch can automatically generate the main attributes (NAS-ID, NAS-IP address
and session ID) in the Accounting-On packets. However, you can also manually
configure the NAS-IP address with the nas-ip command. If you choose to manually
configure the attribute, be sure to configure an appropriate and legal IP address. If this
attribute is not configured, the switch will automatically use the IP address of the VLAN
interface as the NAS-IP address.
Table 1-22 Enable the user re-authentication upon device restart function
Operation
Enter system view
Enter
scheme view
Enable
re-authentication
upon device restart
function
1.6 Displaying AAA&RADIUS Information
After the above configurations, you can execute the display commands in any view to
view the operation of AAA and RADIUS and verify your configuration.
You can use the reset command in user view to clear the corresponding statistics.
Table 1-23 Display AAA information
Display
information about one specific or
all ISP domains
Display the information about
specified or all user connections
Command
system-view
RADIUS radius
radius-scheme-name
the user
accounting-on
enable [ send times |
interval interval ]
Operation
the configuration
Huawei Technologies Proprietary
Chapter 1 AAA&RADIUS Configuration
—
scheme
—
By default,
disabled, and the system can
send at most 15 Accounting-On
packets consecutively at intervals
of three seconds.
Command
display domain [ isp-name ]
display connection [ access-type { dot1x |
mac-authentication } | domain isp-name |
interface interface-type interface-number | ip
ip-address |
radius-scheme radius-scheme-name | vlan
vlan-id | ucibindex ucib-index | user-name
user-name ]
1-29
Description
this function
mac mac-address
is
|