Displaying Multicast Mac Address Configuration - Huawei Quidway S3100 Series Operation Manual

Operation Manual – IGMP Snooping
Quidway S3100 Series Ethernet Switches
Note:
If the multicast MAC address entry you are creating already exists, the system gives
you a prompt.
The switch will not learn a manually added multicast MAC address by IGMP
Snooping. The undo mac-address multicast command can only remove manually
created multicast MAC address entries and cannot remove those learned by the
switch.
To add a port to a manually created multicast MAC address entry, first remove the
entry, and then re-create the entry and specify the port as the forward port of the
entry.
The system does not support the configuration of multicast MAC address on an IRF
port. If you do this, the system will give you a prompt that the multicast MAC address
configuration fails.
You cannot enable port aggregation on a port where you have configured a
multicast MAC address; and you cannot configure a multicast MAC address on an
aggregation port.

3.3 Displaying Multicast MAC Address Configuration

You can use the following display command in any view to display the multicast MAC
address entry/entries you configured manually.
Table 3-2 Display the multicast MAC address entry/entries manually configured
Operation
Display
MAC
entry/entries
configured
the multicast display
address multicast
manually [ mac-address ] [ vlan
vlan-id ]
Huawei Technologies Proprietary
Chapter 3 Multicast MAC Address Entry
Command
mac-address
static
3-2
Configuration
Description
You can use the display
command in any view.