Prerequisites; Mst Region Configuration - Huawei Quidway S3100 Series Operation Manual

Operation Manual – MSTP
Quidway S3100 Series Ethernet Switches
Operation
Network
configuration
MSTP time-related
configuration
Timeout time factor
configuration
Maximum
transmitting speed
configuration
Edge
configuration
Point-to-point
related
configuration
Note:
In a network that contains switches with both GVRP and MSTP employed, GVRP
packets are forwarded along the CIST. If you want to broadcast packets of a specific
VLAN through GVRP, be sure to map the VLAN to the CIST when configuring the
MSTP VLAN mapping table (The CIST of a network is the spanning tree instance
numbered 0.)

1.2.1 Prerequisites

The status of the switches in the spanning trees are determined. That is, the status
(root, branch, or leaf) of each switch in each spanning tree instance is determined.

1.2.2 MST Region Configuration

I. Configuration procedure
Table 1-3 Configure an MST region
Operation
Enter system view
Enter MST region
view
Description
Optional
diameter
The default is recommended.
Optional
The
recommended.
Optional
Optional
The default is recommended.
port
Optional
link
Optional
Command
system-view
stp region-configuration
Huawei Technologies Proprietary
defaults are
—
—
1-8
Chapter 1 MSTP Configuration
Related section
Section 1.2.7 "Network
Diameter Configuration"
Section 1.2.8 "MSTP
Time-related
Configuration"
Section 1.2.9 "Timeout
Time Factor Configuration"
Section 1.2.10 "Maximum
Transmitting Speed
Configuration"
Section 1.2.11 "Edge Port
Configuration"
Section 1.2.12
"Point-to-point
Link-Related
Configuration"
Description