Displaying And Debugging The System-Guard Function; System-Guard Configuration Example - Huawei Quidway S3100 Series Operation Manual

Operation Manual – 802.1x
Quidway S3100 Series Ethernet Switches
Table 3-2 Configure system-guard related parameters
Operation
Enter system view
Configure
system-guard-related
parameters
3.2.3 Specifying system-guard-enabled ports
Table 3-3 lists the operations to specify system-guard-enabled ports.
Table 3-3 Specify system-guard-enabled ports
Operation
Enter system view
Specify
system-guard-enabled
ports

3.3 Displaying and Debugging the System-guard Function

After the above configuration, you can display and verify your configuration by
performing the operation listed in Table 3-4.
Table 3-4 Display and debug the system-guard function
Operation
Display
system-guard
configuration

3.4 System-guard Configuration Example

I. Network requirements
S3100-2 and S3100-3 have users directly attached. They are connected upstream to
S3100-1.
Command
system-view
system-guard
rate-limit interval-time
threshold timeout
Command
system-view
system-guard
interface-list
Command
display system-guard
config
Huawei Technologies Proprietary
3-2
Chapter 3 System-guard Configuration
Description
—
Required
The
system-guard-related
mode
parameters are as follows.
interval-time: 5 seconds
threshold: 64
timeout: 60 seconds
Description
—
permit
Required
Description
This command
executed in any view.
default
can be