Adding An Ethernet Port To Specified Vlans; Configuring Ethernet Ports; Making Basic Port Configuration - Huawei Quidway S3100 Series Operation Manual

Operation Manual – Port
Quidway S3100 Series Ethernet Switches

1.1.4 Adding an Ethernet Port to Specified VLANs

You can add the specified Ethernet port to a specified VLAN. After that, the Ethernet
port can forward the packets of the specified VLAN, so that the VLAN on this switch can
intercommunicate with the same VLAN on the peer switch.
An access port can only be added to one VLAN, while hybrid and trunk ports can be
added to multiple VLANs.
Note that the port shall be added to an existing VLAN.

1.2 Configuring Ethernet Ports

1.2.1 Making Basic Port Configuration

Table 1-3 Make basic port configuration
Operation
Enter system view
Enter
view
Enable
port
Set the description of
the Ethernet port
Set the duplex mode of
the Ethernet port
Set the rate of the
Ethernet port
Set the MDI attribute of
the Ethernet port
Note:
The mdi command is not available on the Ethernet ports of the expansion interface
card.
system-view
Ethernet port interface
interface-number
the Ethernet
undo shutdown
description text
duplex { auto | full | half }
speed { 10 | 100 | 1000 |
auto }
mdi { across | auto | normal }
Huawei Technologies Proprietary
Chapter 1 Basic Port Configuration
Command
interface-type
1-4
Remarks
—
—
By default, the port is
enabled.
Use the shutdown
command to disable the
port.
By default, no
description is defined
for an Ethernet port.
The port defaults to
auto (autonegotiation)
mode.
By default, the speed of
the port is set to auto
mode.
Be default, the MDI
attribute of the port is
set to auto mode.