Enabling Information Output To The Snmp; Displaying And Debugging Information Center - Huawei Quidway S3100 Series Operation Manual

Operation Manual – Information Center
Quidway S3100 Series Ethernet Switches

1.2.7 Enabling Information Output to the SNMP

Table 1-12 lists the related configurations on the switch.
Table 1-12 Enable information output to the SNMP
Operation
Enter system view
Enable
information center
Enable information
output
SNMP
Define
information source
Set the format of
time stamp
Note:
To view debug information of specific modules, you need to set the information type
as debug in the info-center source command, and enable debugging on
corresponding modules with the debugging command as well.
To send information to remote SNMP workstation properly, related configurations
are required on both the switch and the SNMP workstation.

1.3 Displaying and Debugging Information Center

After the above configurations, you can execute the display command in any view to
display the running status of the information center, and thus validate you
configurations. You can also execute the reset command to clear statistics on the
information center.
Command
system-view
the
info-center enable
info-center snmp channel
to the { channel-number
channel-name }
info-center
{ modu-name | default }
an channel { channel-number |
channel-name } [ { log | trap
| debug } * { level severity |
state state } * ]
info-center
{ log | trap | debugging }
{ boot | date | none }
Huawei Technologies Proprietary
—
Optional
By default, the information
center is enabled.
Required
|
By default, SNMP information
goes through channel 5.
source
Required
Optional
This is to set the time stamp
timestamp
format
information output.
This determines how the time
stamp is presented to users.
1-12
Chapter 1 Information Center
Description
for log/debug/trap