Displaying Gvrp; Configuration Example - Huawei Quidway S3100 Series Operation Manual

Operation Manual – GVRP
Quidway S3100 Series Ethernet Switches
Timer
LeaveAll

1.3 Displaying GVRP

After the above configuration, you can use the display commands in any view to
display the configuration information and working condition of GVRP, and thus verify
your configuration. You can use the reset garp statistics command in user view to
clear the GARP statistics.
Table 1-4 Display GVRP
Display the GARP statistics
Display the timeouts of the
GARP timers
Display the GVRP statistics
Display
status
Clear the GARP statistics (in
user view)

1.4 Configuration Example

I. Network requirements
You should enable GVRP on the switches to implement the dynamic registration and
update of VLAN information between the switches.
II. Network diagram
Switch A Switch A Switch A Switch A
Figure 1-2 Network diagram for GVRP configuration
Lower threshold
This lower threshold
greater than the timeout time
of the Leave timer. You can
change threshold
changing the timeout time of
the Leave timer.
Operation
the global GVRP
E1/0/1 E1/ 0/2
Switch B Switch B Switch B Switch B
Huawei Technologies Proprietary
is
32,765 centiseconds
by
Command
display garp statistics [ interface interface-list ]
display garp timer [ interface interface-list ]
display gvrp statistics [ interface interface-list ]
display gvrp status
reset garp statistics [ interface interface-list ]
1-6
Chapter 1 GVRP Configuration
Upper threshold