Modem Connection Establishment - Huawei Quidway S3100 Series Operation Manual

Operation Manual – Login
Quidway S3100 Series Ethernet Switches
II. Configuration on switch when the authentication mode is password
Refer to section 2.5 "Console Port Login Configuration with Authentication Mode Being
Password".
III. Configuration on switch when the authentication mode is scheme
Refer to section 2.6 "Console Port Login Configuration with Authentication Mode Being
Scheme".

4.4 Modem Connection Establishment

Step 1: Configure the user name and password on the switch. Refer to section 2.4
"Console Port Login Configuration with Authentication Mode Being None", section 2.5
"Console Port Login Configuration with Authentication Mode Being Password", and
section 2.6
Scheme" for more.
Step 2: Perform the following configuration on the modem directly connected to the
switch.
AT&F
ATS0=1
first ring
AT&D
AT&K0 ----------------------- Disable flow control
AT&R1 ----------------------- Ignore RTS signal
AT&S0 ----------------------- Set DSR to high level by force
ATEQ1&W
response and the result, save the changes
You can verify your configuration by executing the AT&V command.
Note:
The configuration commands and the output of different modems may differ. Refer to
the user manual of the modem when performing the above configuration.
It is recommended that the baud rate of the AUX port (also the Console port) be set to a
value lower than the transmission speed of the modem. Otherwise, packets may get
lost.
Step 3: Connect your PC, the modems, and the switch, as shown in the following figure.
"Console Port Login Configuration with Authentication Mode Being
----------------------- Restore the factory settings
----------------------- Configure to answer automatically after the
----------------------- Ignore DTR signal
----------------------- Disable the modem from returning command
Huawei Technologies Proprietary
Chapter 4 Logging in Using Modem
4-3