Point-To-Point Link-Related Configuration - Huawei Quidway S3100 Series Operation Manual

Operation Manual – MSTP
Quidway S3100 Series Ethernet Switches
III. Configuration example
# Configure Ethernet1/0/1 port as an edge port.
Configure in system view.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] stp interface ethernet1/0/1 edged-port enable
Configure in Ethernet port view.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] interface ethernet1/0/1
[Quidway-Ethernet1/0/1] stp edged-port enable

1.2.12 Point-to-point Link-Related Configuration

A point-to-point link directly connects two switches. If the roles of the two ports at the
two ends of a point-to-point link meet certain criteria, the two ports can transit to the
forwarding state rapidly by exchanging synchronization packets, eliminating the
forwarding delay.
You can specify whether or not the link connected to a port is a point-to-point link in one
of the following two ways.
I. Configuration procedure (in system view)
Table 1-16 Specify whether or not the links connected to the specified ports are
point-to-point links (in system view)
Operation
Enter system view
Specify whether or
not
connected to the
specified ports are
point-to-point links
Command
system-view
stp
the links
interface-list
point-to-point
{
force-true
force-false | auto }
Huawei Technologies Proprietary
—
Required
The auto keyword is adopted by
default.
The force-true keyword specifies
that the links connected to the
specified ports are point-to-point
interface
links.
The force-false keyword specifies
that the links connected to the
|
specified ports are not point-to-point
links.
The auto keyword specifies to
automatically determine whether or
not the links connected to the
specified ports are point-to-point
links.
1-21
Chapter 1 MSTP Configuration
Description