Configuration Example - Huawei Quidway S3100 Series Operation Manual

Operation Manual – Login
Quidway S3100 Series Ethernet Switches
Table 3-5 Determine the command level when users logging into switches are not
authenticated
Authentication mode
None
(authentication-mode
none)

3.2.2 Configuration Example

I. Network requirements
Assume that you are a level 3 AUX user and want to perform the following configuration
for Telnet users logging into VTY 0:
Do not authenticate users logging into VTY 0.
Commands of level 2 are available to users logging into VTY 0.
Telnet protocol is supported.
The screen can contain up to 30 lines.
The history command buffer can contain up to 20 commands.
The timeout time of VTY 0 is 6 minutes.
II. Network diagram
Figure 3-1 Network diagram for Telnet configuration (with the authentication mode
being none)
III. Configuration procedure
# Enter system view.
Scenario
User type
VTY users
RS-232 RS-232
Console cable Console cable
Huawei Technologies Proprietary
Chapter 3 Logging in through Telnet
Command
The user
level level command
not executed
The user
level level command
already executed
Console port Console port
3-5
Command
level
privilege
Level 0
privilege Determined
by the level
argument