Configuring Whether Or Not To Send Trap Message When Radius Server Is Down - Huawei Quidway S3100 Series Operation Manual

Operation Manual – AAA&RADIUS
Quidway S3100 Series Ethernet Switches
Table 1-20 Set the timers of RADIUS server
Operation
Enter
view
Create
RADIUS
scheme
enter its view
Set
response
timeout time of
RADIUS servers
Set the wait time
for the primary
server to restore
the active state
Set the real-time
accounting
interval
1.5.11 Configuring Whether or not to Send Trap Message When RADIUS
Server is Down
Table 1-21 Configure whether or not to send trap message when RADIUS server is
down
Operation
Enter system view
Enable the sending
of trap
when
server is down
Note:
This configuration takes effect on all RADIUS schemes.
A device considers its RADIUS server as being down if it has tried the configured
maximum times to send packets to its RADIUS server but does not receive any
response.
Command
system
system-view
a
radius
and radius-scheme-name
the
timer response-timeout
seconds, or
timer second
timer quiet minutes
timer realtime-accounting
minutes
system-view
radius
message { authentication-server-do
RADIUS wn
accounting-server-down }
Huawei Technologies Proprietary
Chapter 1 AAA&RADIUS Configuration
—
Required
scheme
By default, a RADIUS scheme
named "system" has already
been created in the system.
Optional
By default, the response timeout
timer of RADIUS servers expires
in three seconds.
Optional
By default, the primary server
waits
restoring the active state.
Optional
By
accounting interval is 12 minutes.
Command
trap
|
1-27
Description
five minutes
default, the real-time
Description
—
Optional
By default, the switch does
not send trap message when
its RADIUS server is down.
before