Creating A Radius Scheme; Configuring Radius Authentication/Authorization Servers - Huawei Quidway S3100 Series Operation Manual

Operation Manual – AAA&RADIUS
Quidway S3100 Series Ethernet Switches
In an actual network environment, you can configure the above parameters as required.
But you should configure at least one authentication/authorization server and one
accounting server, and at the same time, you should keep the RADIUS service port
settings on the switch consistent with those on the RADIUS servers.
Note:
Actually, the RADIUS protocol configuration only defines the parameters used for
information exchange between the switch and the RADIUS servers. To make these
parameters take effect, you must reference the RADIUS scheme configured with these
parameters in an ISP domain view. For specific configuration commands, refer to
section 1.3 "AAA Configuration".

1.5.1 Creating a RADIUS Scheme

The RADIUS protocol configuration is performed on a RADIUS scheme basis. You
should first create a RADIUS scheme and enter its view before performing other
RADIUS protocol configurations.
Table 1-11 Create a RADIUS scheme
Operation
Enter system view
Create
scheme and enter its
view
Caution:
A RADIUS scheme can be referenced by multiple ISP domains simultaneously.

1.5.2 Configuring RADIUS Authentication/Authorization Servers

Table 1-12 Configure RADIUS authentication/authorization server
Enter system view
system-view
a RADIUS
radius
radius-scheme-name
Operation
Huawei Technologies Proprietary
Chapter 1 AAA&RADIUS Configuration
Command
—
Required
scheme
By default, a RADIUS scheme
named "system" has already
been created in the system.
Command
—
system-view
1-18
Description
Description