Caller Id Display For Car Key Assignment - NEC Electra Elite IPK Programming Manual

Document Revision 4
___________________________________________________________________________________
4-49 Caller ID Display for CAR Key
Assignment
General Description
Use this Memory Block to assign one Multiline Terminal per CAR to display ANI/Caller
ID Indication on incoming CAR calls.
This Memory Block is used for R1600 and lower. For R1700 or higher, it is no longer
required.
Display
D a t a
C A R P o r t
N o .
N o .
0 1 / 4 9 : C A L L I D
T I M E
Programming Procedures
1 Go off-line.
D I
2 Press LK4 +
3 Use the dial pad to enter Tel port No for CAR Port No. 01.
Use the following to enter data:
J
t o move the cursor left
L
t o move the cursor right
K I
t
~ o enter numeric data or Tel Port No.
D
– OR –
B
to go to next assigned Tel Port No.
B
A
+
B
B
+
C
G
+
4 Press to write the data and display the next Memory Block.
5 Program the next Memory Block or press
To display ANI/Caller ID Indication for normal incoming CO calls and CAR incoming calls, both ANI/Caller ID
Indication and Ring assignment must be assigned for the terminal in System Programming. A maximum of 15
Multiline Terminals can be assigned system-wide to display caller identification for normal incoming CO calls and
CAR incoming calls using Memory Block 1-1-78 (Caller ID Display Assignment for System Mode). A sixteenth
Multiline Terminal can be assigned to display ANI/Caller ID Indication for CAR incoming calls per CAR using this
Memory Block.
___________________________________________________________________________________
2 - 562
T e l
P o r t N o .
~
T i t l e
( 0 1
0 0
D I S P L A Y
to access the Memory Block.
t o enter A for Port Numbers 100~109
t o enter B for Port Numbers 110~119
t o enter C for Port Number 120
E
C 0 )
to go back on-line.
Notes
Electra Elite IPK
Telephone Mode
Submode
PC Programming
Default Value
Not Specified
Memory Blocks
4
—
Data No.
49
+AI