Co/Pbx Busy Forward Station Assignment - NEC Electra Elite IPK Programming Manual

Document Revision 4
___________________________________________________________________________________
4-13 CO/PBX Busy Forward Station
Assignment
General Description
Use this Memory Block to specify up to two telephones to ring when a CO/PBX call
terminates at a busy station.
Display
T e l
P o r t
D a t a
N o .
N o .
( 0 1 ~ C 0 )
0 1 / 1 3 : F W D
T I M E
Programming Procedures
1 Go off-line.
A C
2 Press LK4 +
3 Use dial pad to change data.
Use the following to enter data:
J
t o move the cursor left
L
t o move the cursor right
K I
~ t o enter numeric data or Tel Port No.
D
– OR –
B
to go to next assigned Tel Port No.
B
A
+
B
B
+
C
+
G
Setting Data: Port No. 01
4 Press to write the data and display Forward No. 2.
G
5 Enter second transfer Port No.
6 Press to write the data and display the next Memory Block.
7 Program the next Memory Block or press
1. When the Multiline Terminal where the forward is initially set (Forward 1) is busy, the call is forwarded to a
second specified station (Forward 2).
2. When all three stations are busy, the first station rings.
3. Telephone ports A0~C0 are ports 100~120.
___________________________________________________________________________________
2 - 520
F o r w a r d
S e t t i n g
N o .
D a t a
T i t l e 1 / 2
1 =
D I S P L A Y
to access the Memory Block.
t o enter A for Port Numbers 100~109.
t o enter B for Port Numbers 110~119
t o enter C for Port Number 120
~
96
E
to go back on-line.
Default Values
Notes
Electra Elite IPK
Telephone Mode
Submode
Data No.
PC Programming
Not specified
Memory Blocks
4
—
13
+BTT