1-11-00 T1 Signal Format Selection - NEC Electra Elite IPK Programming Manual

Electra Elite IPK
___________________________________________________________________________________

1-11-00 T1 Signal Format Selection

General Description
Use this Memory Block to specify the signal format of the T1 trunk connected to the
system. The signal format used (12- or 24-Multiframe) depends on the channel service
unit/demarcation (CSU/D mark) equipment being used.
Display
D a t a
D T I N o .
N o .
( 0 1 ~ 0 8 )
0 1 / 0 0 : F R A M E 0 1 / 0 0 : F R A M E
T I M E T I M E
Settings
LK 1 LK 2
12 24
(SF) (ESF)
Programming Procedures
1 Go off-line.
2 Press LK1 + LK11 to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Setting Data:
SF = Superframe Format (12-Multiframe)
ESF = Extended Superframe Format (24-Multiframe)
G
4 Press to write the data. The next Memory Block is displayed.
5 Program the next Memory Block or press
Related Programming
M.B. Number Memory Block Name
7-1 Card Interface Slot Assignment
The DTI-U( ) ETU must be assigned in the system to set this Memory Block.
___________________________________________________________________________________
Programming Manual
S e t t i n g
T i t l e D a t a
= 2 4 = 2 4
D I S P L A Y D I S P L A Y
LK 3 LK 4 LK 5
E
to go back on-line.
LK 6 LK 7
Notes
Document Revision 4
System Mode
1
Submode
11
Data No.
00
PC Programming
+AD
LK 8
The shaded
selection is the
default.
2 - 289