Notes And Restriction For Using Secondary Ethernet (Optional) - Fuji Xerox Versant 80 Press User Manual

However, if the machine was turned off immediately after a computer instructed a print
job, the job may remain on the computer. In this case, when the machine is turned on, the
data stored on the computer is printed before any jobs instructed subsequently.
When [Receiving Buffer - LPD] is set to [Spool to Hard Disk]
All print data spooled in the machine hard disk, including the data which is being printed,
is saved. In this case, when the machine is turned on, the data stored on the machine hard
disk is printed before any jobs instructed subsequently.
When [Receiving Buffer - LPD] is set to [No Spooling]
All print data spooled in the machine receiving buffer, including the data which is being
printed, is erased. The print data does not remain when the machine is turned on again.
However, if the machine was turned off immediately after a computer instructed a print
job, the job may remain on the computer. In this case, when the machine is turned on, the
data stored on the computer is printed before any jobs instructed subsequently.
While Printing
When [Receiving Buffer - LPD] is set to either [Spool to Hard Disk] or [Spool to Memory]
If the transmitted print data size exceeds the available capacity of either hard disk or
memory, the print data is not received.
Note
When [Receiving Buffer - LPD] is set to [No Spooling]
When the machine receives a print request from a computer, the machine cannot accept
print requests from any other computers.
When a computer's IP address or a computer name is changed
When you change a computer's IP address or a computer name, queries and cancel
processes submitted from the machine are no longer executed correctly. Thus, turn the
machine off and on when there is no print data in the receiving buffer.
Note

Notes and Restriction for Using Secondary Ethernet (Optional)

This section describes notes and restrictions to observe when using Secondary Ethernet
(optional).
The exceptions setting dialog box may be displayed when you access CentreWare
Internet Services using FQDN by Ethernet 2 while enabling [HTTP - SSL/TLS
Communication].
The job log does not record Ethernet1 and Ethernet2 separately. You cannot identify
which network has transmitted a job.
The remaining level of consumables and the meter value information transmitted from
the machine are identical between Ethernet 1 and Ethernet 2. When you use the software
which is not supplied by Fuji Xerox to check the machine usage status, please do not set
IP address to avoid the duplication of machine information. Instead of IP address, set the
machine-specific information such as UUID depending on the software you use.
When [LPD Print Queue] is set to [Job Submission Order], no priority of print order occurs
between Ethernet 1 and Ethernet 2.
• When the print data exceeds the receivable size, some computers may immediately re-transmit the
print data. In this case, the computer appears to be not operating. Remedy this problem by
canceling the print data transmission from the computer.
• From the control panel on the machine, you can cancel print jobs or force the machine to print the
jobs remaining in the receiving buffer. For more information on the operation, refer to "Job Status"
(P.357).
Notes and Restrictions
1003
23