Brocade Communications Systems WFT-2D User Manual page 179

4. Select the Built-in FTP Server check box.
5. Change your password by entering a new password in the Password and Confirm Password
6. Click Test to test the FTP server.
7.
Configuring an internal SCP or SFTP server
NOTE
SCP is supported on Fabric OS devices running 5.3 and later.
NOTE
SFTP is supported on Fabric OS devices running 7.0 and later.
To configure the internal SCP or SFTP server settings, complete the following steps.
1. Select Server > Options.
2. Select FTP/SCP/SFTP in the Category list.
3. Select the Use built-in FTP/SCP/SFTP Server option to use the default built-in SCP or SFTP
4. Select the SCP/SFTP Server check box.
5. Change your password by entering a new password in the Password and Confirm Password
6. Select the protocol (SCP or SFTP) from the Preferred Protocol list.
Brocade Network Advisor SAN User Manual
53-1003154-01
fields.
The default password is passw0rd (where 0 is a zero).
An "FTP Server running successfully" or an error message displays.
If you receive an error message, make sure your credentials are correct, the server is running,
the remote directory path exists, and you have the correct access permission; then try again.
Click Apply or OK to save your work.
The Options dialog box displays.
The FTP/SCP/SFTP pane displays
FIGURE 44
Options dialog box (FTP/SCP/SFTP pane)
server.
All active fields are mandatory. The default user name is admin. The full path to the built-in SCP
or SFTP directory displays in the Root Directory field.
fields.
The default password is passw0rd (where 0 is a zero).
Software Configuration
(Figure 43).
4
127