Show Ip Ospf Interface Stats - Dell Networking 7048 Reference Manual

console#show ip ospf interface brief
Admin
Interface Mode
------------ -------- ----------- ------ ----- ----- ----- ------ ------ ------
Vl10 Enable
Vl20 Enable
Vl100 Enable
loopback 1 Enable

show ip ospf interface stats

Use the show ip ospf interface stats command in User EXEC mode to display
the statistics for a specific interface. The information is only displayed if
OSPF is enabled.
Syntax
show ip ospf interface stats vlan
vlan-id — Valid VLAN ID.
•
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
This command has no user guidelines.
Example
The following example displays the ospf statistics for VLAN 15.
console>show ip ospf interface stats vlan15
OSPF Area ID....................................... 0.0.0.0
Area Border Router Count................................. 0
AS Border Router Count................................... 0
Area LSA Count........................................... 1
IP Address......................................... 2.2.2.2
Router
Area ID Prior. Cost
0.0.0.10 1
0.0.0.1 1
0.0.0.111 1
0.0.0.0 1
vlan-id
Hello Dead
Int. Int.
Val. Val.
10 10 40
10 10 40
10 10 40
1 10 40
OSPF Commands
Retrax LSA
Int. Tranx Ack
Val. Delay Intval
5 1 1
5 1 1
5 1 1
5 1 1
1221