Show Interfaces Switchport - Dell Force10 Z9000 Reference Manual

Ftos command line reference guide for the z9000 system ftos 9.1.(0.0)

Hide thumbs Also See for Force10 Z9000:

Table of Contents

show interfaces

show interfaces switchport

Display only virtual and physical interfaces in Layer 2 mode. This command displays the Layer 2 mode interfaces' IEEE

802.1Q tag status and VLAN membership.

C-Series, E-Series, S-Series, Z-Series

show interfaces switchport [interface [linecard slot-number] |

stack-unit unit-id ]

– displays information on a specific physical interface or virtual interface.

(OPTIONAL) Enter one of the following keywords and slot/port or

number information:

For a 1-Gigabit Ethernet interface, enter the keyword

GigabitEthernet followed by the slot/port information.

For a Port Channel interface, enter the keywords port-

channel followed by a number. For the C-Series and S-

Series, the range is 1 to 128. For the E-Series, the range is 1 to

255 for TeraScale and 1 to 512 for ExaScale.

For SONET interfaces, enter the keyword sonet followed by

the slot/port information. This keyword is only available on E-

Series and C-Series.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet followed by the slot/port

information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE followed by the slot/port information.

Enter the keyword backup to view the backup interface for

this interface.

(OPTIONAL) Enter the keyword linecard followed by the slot

number. For the C-Series, the range is 0 to 7 for C300 and 0 to 3 for

C150. For the E-Series, the range is 0 to 13 on the E1200, 0 to 6 on the

E600, and 0 to 5 on the E300

(OPTIONAL) Enter the keywords stack-unit followed by the stack

member number. This option is available only on S-Series. The range