Area Range (Router Ospfv) - Dell Networking 7048 Reference Manual

area range (Router OSPFv3)
Use the area range command in Router OSPF Configuration mode to
configure a summary prefix for routes learned in a given area. If the area has
not been previously created, this command creates the area and then applies
the range parameters. There are two types of area ranges. An area range can be
configured to summarize intra-area routes. An ABR advertises the range
rather than the specific intra-area route as a type 3 summary LSA. Also, an
area range can be configured at the edge of an NSSA to summarize external
routes reachable within the NSSA. The range is advertised as a type 5 external
LSA. Use the no form of the command to remove the summary prefix
configuration for routes learned in the specified area.
Syntax
area-id
area range
nssaexternallink} [advertise | not-advertise]
area-id
no area range
nssaexternallink}
Parameter Description
Parameter
areaid
ipv6-prefix/prefix-
length
summarylink
nssaexternallink
advertise
not-advertise
Default Configuration
This command has no default configuration.
Command Mode
Router OSPFv3 Configuration mode.
ipv6-prefix/prefix-length
ipv6-prefix/prefix-length
Description
Valid OSPFv3 area identifier.
Valid route prefix.
LSDB type
LSDB type.
Allows area range to be advertised.
Suppresses area range from being advertised.
{summarylink |
{summarylink |
OSPFv3 Commands
1245