Show Ip Ospf Virtual-Link - Dell Networking 7048 Reference Manual

show ip ospf virtual-link

Use the show ip ospf virtual-link command in Privileged EXEC mode to
display the OSPF Virtual Interface information for a specific area and
neighbor or for all.
Syntax
show ip ospf virtual-link [
area-id — Identifies the OSPF area whose ranges are being displayed.
•
(Range: IP address or decimal from 0–4294967295)
neighbor-id — Identifies the neighbor's router ID. (Range: Valid IP
•
address)
Default Configuration
Show information for all OSPF Virtual Interfaces.
Command Mode
User EXEC, Privileged EXEC modes, Config mode and all Config sub-modes
User Guidelines
This command has no user guidelines.
Example
The following example displays the OSPF Virtual Interface information for
area 10 and its neighbor.
console#show ip ospf virtual-link 10 192.168.2.2
Area ID........................................ 10
Neighbor Router ID............................. 192.168.2.2
Hello Interval................................. 10
Dead Interval.................................. 655555
Iftransit Delay Interval....................... 1
Retransmit Interval............................ 5
State.......................................... down
1232
OSPF Commands
area-id neighbor-id
]