Show Interfaces Switchport - Dell N1100-ON Reference Manual

show interfaces switchport

Use the show interfaces switchport command to display the complete
switchport VLAN configuration for all possible switch mode configurations:
access, dot1q-tunnel, general, trunk, and (private VLAN) host or (private
VLAN) promiscuous.
Syntax
show interfaces switchport {{gigabitethernet unit/slot/port | port-channel
port-channel-number | tengigabitethernet unit/slot/port|
fortygigabitethernet unit/slot/port}}
Default Configuration
If no interface parameter is given, all interfaces are shown.
Command Mode
Privileged Exec mode, Interface Configuration mode and all Configuration
submodes
User Guidelines
Each of the switchport modes can be configured independently for a port or
port channel. The configurations are retained even when the port is
configured in a different mode.
It is recommended that the private VLAN host ports be configured as
spanning-tree portfast.
Examples
The following example displays switchport configuration individually for
gi1/0/1.
switch-top(config-if-Gi1/0/1)#show interfaces switchport gi1/0/1
Port: Gi1/0/1
VLAN Membership Mode: Trunk Mode
Access Mode VLAN: 1 (default)
General Mode PVID: 1 (default)
General Mode Ingress Filtering: Enabled
General Mode Acceptable Frame Type: Admit All
General Mode Dynamically Added VLANs:
799
Layer 2 Switching Commands