Set Rfdetect Log; Set Rfdetect Signature - D-Link DWS-1008 Cli Reference Manual

See Also:
• clear rfdetect ignore
• show rfdetect ignore

set rfdetect log

Disables or reenables generation of log messages when rogues are detected or when they
disappear.
Syntax: set rfdetect log {enable | disable}
enable
disable
Defaults: RF detection logging is enabled by default.
Access: Enabled.
Usage: The log messages for rogues are generated only on the seed and appear only in the
seed's log message buffer. Use the show log buffer command to display the messages in the
seed switch's log message buffer.
Examples: The following command enables RF detection logging for the Mobility Domain
managed by this seed switch:
DWS-1008# set rfdetect log enable
success: rfdetect logging is enabled.
See Also:
• show log buffer

set rfdetect signature

Enables AP signatures. An AP signature is a set of bits in a management frame sent by an AP
that identifies that AP to MSS. If someone attempts to spoof management packets from a D-Link
AP, MSS can detect the spoof attempt.
Syntax: set rfdetect signature {enable | disable}
enable
disable
Defaults: AP signatures are disabled by default.
Access: Enabled.
D-Link DWS-1008 CLI Manual
Enables logging of rogues.
Disables logging of rogues.
Enables AP signatures.
Disables AP signatures.