Send Info - Nortel Meridian Meridian 1 Scripting Manual

Host Data Exchange commands

SEND INFO

Use the SEND INFO command to send data to and start a third-party
application, such as a screen-pop application. You must use the SEND
REQUEST and GET RESPONSE commands to request and receive
information.
Script syntax
SEND INFO
A comma is not used between the application ID and the first variable, but
commas are mandatory between the variables (additional spaces are optional).
Parameters
Enter information for the following parameters:
<provider_ID>
with Contact Center Manager. Replace this parameter with an integer type
variable.
<variable>
10), that contains the data you want to send to the third-party application.
Lists of variables are single variable values separated by commas. For a list
of variable types that you can use with this command, see "Using intrinsics
and variables in HDX commands" on page 328.
Restrictions
Do not insert the GIVE BUSY or GIVE OVERFLOW command immediately
after the SEND INFO command.
330
<provider_ID> [<variable> | <list_of_variables>]
The identifier that the HDX application uses to register
or
<list_of_variables>
The variable, or list of variables (up to
Contact Center Manager
Standard 8.04