Reset Garp Statistics - HP E4510-48G Command Reference Manual

Parameters
fixed: Sets the registration type to fixed.
forbidden: Sets the registration type to forbidden.
normal: Sets the registration type to normal.
Description
Use the gvrp registration command to configure the GVRP registration type on a port (in Ethernet or
Layer-2 aggregate interface view) or all ports in a port group (in port group view).
Use the undo gvrp registration command to restore the default on a port, or on all ports in a port
group depending on the view the command is executed.
The default GVRP registration type is normal.
Note that, this command is only available on trunk ports.
Related commands: display garp statistics.
Examples
# Set the GVRP registration type to fixed on port GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port link-type trunk
[Sysname-GigabitEthernet1/0/1] gvrp registration fixed

reset garp statistics

Syntax
reset garp statistics [ interface interface-list ]
View
User view
Default Level
2: System level
Parameters
interface interface-list: Defines one or multiple Ethernet ports for which the GARP statistics are to be
cleared. You can provide up to 10 Ethernet port lists, by each of which you can specify an individual
port in the form of interface-type interface-number, or a port range in the form of interface-type
interface-number1 to interface-type interface-number2, where the end-port number specified by
interface-number2 must be greater than the start-port number specified by interface-number1. If no
ports are specified, this command clears the GARP statistics on all ports.
Description
Use the reset garp statistics command to clear the GARP statistics on specified ports or all ports if no
ports are specified.
9-10