Gvrp; Gvrp Registration - HP E4510-48G Command Reference Manual

gvrp

Syntax
gvrp
undo gvrp
View
System view, Ethernet interface view, Layer-2 aggregate interface view, port group view
Default Level
2: System level
Parameters
None
Description
Use the gvrp command to enable GVRP globally (in system view), on a port (in Ethernet or Layer-2
aggregate interface view), or on all ports in a port group (in port group view).
Use the undo gvrp command to disable GVRP globally, on a port, or on all ports in a port group
depending on the view where the command is executed.
By default, GVRP is disabled.
Note that:
To enable GVRP on a port, you need to enable it globally first and then on the port.
You can use this command on trunk ports only.
You cannot change the link type of a GVRP-enabled trunk port.
Related commands: display gvrp status.
Examples
# Enable GVRP globally.
<Sysname> system-view
[Sysname] gvrp
GVRP is enabled globally.

gvrp registration

Syntax
gvrp registration { fixed | forbidden | normal }
undo gvrp registration
View
Ethernet interface view, Layer-2 aggregate interface view, port group view
Default Level
2: System level
9-9