Use the undo lldp encapsulation command to restore the default encapsulation format for LLDPDUs.
By default, Ethernet II encapsulation applies.
The command does not apply to LLDP-CDP packets, which use only SNAP encapsulation.
Examples
# Configure the encapsulation format for LLDPDUs as SNAP on GigabitEthernet1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] lldp encapsulation snap
lldp fast-count
Syntax
lldp fast-count count
undo lldp fast-count
View
System view
Default level
2: System level
Parameters
count: Number of the LLDPDUs to be sent successively when a new neighboring device is detected.
This argument ranges from 1 to 10.
Description
Use the lldp fast-count command to set the number of the LLDPDUs to be sent successively when a
new neighboring device is detected.
Use the undo lldp fast-count command to restore the default.
By default, the number is 3.
Examples
# Configure to send four LLDP successively when a new neighboring device is detected.
<Sysname> system-view
[Sysname] lldp fast-count 4
5-19