Garp Timer Hold; Garp Timer Join - HP E4510-48G Command Reference Manual

Operations of adding VLAN to TRUNK
Operations of deleting VLAN from TRUNK

garp timer hold

Syntax
garp timer hold timer-value
undo garp timer hold
View
Ethernet interface view, Layer-2 aggregate interface view, port group view
Default Level
2: System level
Parameters
timer-value: Hold timer setting (in centiseconds), which must be a multiple of 5 in the range of 10
(inclusive) and half of the Join timer setting (inclusive). When the Join timer is set to the default, the
value range for the Hold timer is 10 (inclusive) to 10 (inclusive).
One second equals 100 centiseconds.
Description
Use the garp timer hold command to set the GARP Hold timer for an Ethernet port, Layer-2
aggregate interface, or all ports in a port group.
Use the undo garp timer hold command to restore the default of the GARP Hold timer. This may fail if
the default is beyond the valid value range for the Hold timer.
By default, the hold timer is set to 10 centiseconds.
Related commands: display garp timer, garp timer join.
Examples
# Set the GARP Hold timer to 15 centiseconds, assuming that the Join timer is 30 centiseconds.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] garp timer hold 15

garp timer join

Syntax
garp timer join timer-value
undo garp timer join
: 2-100
: none
9-6