Qinq Ethernet-Type - HP E4510-48G Command Reference Manual

[Sysname] port-group manual 1
[Sysname-port-group-manual-1] group-member gigabitethernet 1/0/1 to gigabitethernet 1/0/6
[Sysname-port-group-manual-1] qinq enable

qinq ethernet-type

Syntax
qinq ethernet-type hex-value
undo qinq ethernet-type
View
System view
Default Level
2: System level
Parameters
hex-value: Hexadecimal protocol type value, in the range of 0x0001 to 0xFFFF. However, do not set it
to any of the protocol type values listed in
Table 10-1 Common protocol type values
ARP
PUP
RARP
IP
IPv6
PPPoE
MPLS
IPX/SPX
IS-IS
LACP
802.1x
Cluster
Reserved
Description
Use the qinq ethernet-type command to configure the TPID value in VLAN tags.
Use the undo qinq ethernet-type command to restore the TPID value in VLAN tags to the system
default
By default, the TPID value is 0x8100.
Note that :
Protocol type
Table 10-1.
0x0806
0x0200
0x8035
0x0800
0x86DD
0x8863/0x8864
0x8847/0x8848
0x8137
0x8000
0x8809
0x888E
0x88A7
0xFFFD/0xFFFE/0xFFFF
10-4
Value