Qinq Vid - HP E4510-48G Command Reference Manual

Configuration made in system view takes effect on all ports.
Examples
# Set the TPID value to 0x8200 globally.
<Sysname> system-view
[Sysname] qinq ethernet-type 8200

qinq vid

Syntax
qinq vid vlan-id
undo qinq vid vlan-id
View
Ethernet interface view, Layer-2 aggregate interface view, port group view
Default Level
2: System level
Parameters
vlan-id: Outer VLAN ID, in the range of 1 to 4094.
Description
Use the qinq vid command to enter QinQ view and configure the outer VLAN tag for the port to add.
Use the undo qinq vid command to remove all configurations corresponding to the outer VLAN ID
performed in QinQ view.
By default, the outer VLAN tag is the port's default VLAN tag.
Note that:
Configuration made in Ethernet interface view takes effect on the current port only. Configuration
made in Layer-2 aggregate interface view takes effect on the Layer-2 aggregate interface and the
member ports in its aggregation group. Configuration made in port group view takes effect on all
ports in the port group.
You can configure this command on a Layer-2 aggregate interface and its member ports
separately. Configuration made on an aggregation member port takes effect immediately. For
detailed information about link aggregation, refer to Link Aggregation Configuration in the Access
Volume.
Related commands: raw-vlan-id inbound.
Examples
# Configure GigabitEthernet 1/0/1 to tag frames with outer VLAN 10.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qinq vid 10
# Configure all the ports in port group 1 to tag frames with outer VLAN 10.
<Sysname> system-view
10-5