Traps; Figure 6-3 - Traps Configuration - Motorola APEX1000 Installation And Operation Manual

Item
•
IP Address in Use
•
Subnet Mask in
Use
•
In Use Reason
*Any changes to these parameters require an APEX1000 system reboot.

Traps

This tab provides settings for Trap Receivers. You can configure up to four trap receiver
IP addresses as well as different throttling rates for each trap receiver:
Item
IP Address
Throttling Rate
Configuration • System Configuration
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
573408-001-a
Definition
These settings provide an immediate alert when ENET 2 is in use for
communication with the REM1000 when in Direct Mode.
ENET 2 configuration parameters are grayed out and unchangeable when QAM
Redundancy is enabled and REM1000 Communication mode is set to Direct.
Figure 6-3 — Traps Configuration
Trap Receiver values
Definition
Shows the IP address of the destination trap receiver. This value can be a valid
Singlecast or Multicast IP address (class A, B, C, or D).
A value of 0.0.0.0 indicates that no destination receiver address is defined for
the corresponding index.
Applicable values are 1 – 10, representing the maximum number of traps the
APEX1000 will issue in one second (to a specific trap receiver).
B
66