The Adjustment Of Base Reference Point; The Adjustment Of Print Reference Position - SATO CL4NX Operator's Manual

7 Appendix

7.4 The Adjustment of Base Reference Point

7.4.1

The Adjustment of Print Reference Position

Set the Pitch in Adjustments under Printing menu to adjust the print reference position.
Media feed direction
Adjustment for
"+" value
adjustment
Adjustment for
"-" value
Note
The above base reference point for printing will be the stop position when sensor type is set to Gap sensor.
Adjust the print reference position with the procedures as follows:
1
When the printer is in online mode, press
the button on the operator panel to
change to offline mode
2
Press the
menu.
210
CL4NX Operator Manual
Base reference
point for printing
(Print head)
No
button to show Settings
Gap sensor
-3.75 mm (-0.15") ~ +3.75 mm (+0.15")
Setting range:
203 dpi: -30 to +30 dot
305 dpi: -45 to +45 dot
609 dpi: -90 to +90 dot