Section 8: Appendix
8.7 OFFSET POSITION ADJUSTMENT
This setting adjusts the option (Cutter, Dispenser, Tear off) stop position after a print out.
By using VR3 potentiometer, the stop position can be adjusted within the range of ±3.75mm (±0.15").
A positive value moves the leading edge of the label forward (away from the print head) while a negative
value moves the leading edge of the label back toward the mechanism.
+ Adjustment
(Turn VR3 to the right)
- Adjustment
(Turn VR3 to the left)
In addition to the above setting, the Offset position can also be adjusted by using SATO Utilities Tool
application or by sending command <PO> from the host. The setting range is within ±99 dots.(One exception
is for the Tear off mode; for the Tear off mode, the range is -60 dots to +99 dots). This setting is normally not
necessary. Use VR3 potentiometer on the printer for permanent setting.
Page 8-12
Adjustment of Offset setting
Stop position for
cutting,dispense
or tear-off
Label feed direction
zero
Adjustment
+3.75mm
(+0.15")
Reference position
for printing
-3.75mm
(-0.15")
CG2 Series Operator Manual