Optional Accessories Specifications - SATO TG3 Series Operator's Manual

Section 6: Basic Specifications

6.2 OPTIONAL ACCESSORIES SPECIFICATIONS

LARGE-SIZED STACKER SPECIFICATIONS
Model name
Maximun stack height
Tag feed speed
Media Type
Media Size
Thickness
Tag pressure
Sensor
Communication
(Connection)
Power supply
Motor
Dimensions
Weight
Fixation (Installation) method
Accessories
Page 6-8
150mm (5.9") (Paper thickness 0.26 mm (0.01"), approximately 500 tags)
Tag * Use the optional weight when the tag length is 90mm or more.
* Use the optional spacer when the length of laminated tag and glossy tag are
90mm (3.5") or more.
Some restrictions may apply to the tag size due to tag curling when the diameter of
tag roll core is 3-inch.
Outputs the "stacker full" signal to the EXT (the printer) at the time of error
Input: Amphenol 14-pin Male (EXT connector connection)
* Connecting with the computer (Rewinder and daisy connection inside)
EXT terminal (for handshake):
#3 (Input): Winding motor control
#5 (Output): Rewinder full + stacker full
#6 (Input): Stacker motor control
Output: Amphenol 14-pin Female (EXT connector connection)
* Connecting with the rewinder (RWG500/RWS300)
EXT terminal (for handshake):
#3 (Input): Winding motor control
#5 (Output): Rewinder full
Supplied from the printer unit (EXT connector).
EXT terminal:
# 2 : GND
# 12 : DC+24V
# 13 : DC+5V
Tag stopper, Joint plate, Optional weight (For the tag length of 90mm or more),
Optional spacer with magnet (Use the optional spacer when the length of laminated
tag and glossy tag are 90mm or more), Instruction guide for optional spacer
250mm/sec (9.8" per sec)
Tag only (Use of label is not acceptable)
* Refer to the Consumables Specifications for more details.
Make sure the tag size meets the following conditions.
Width: 32 to 83 mm (1.3" to 3.3")
Pitch: 25 to 150 mm (1" to 5.9")
Tag: 0.159 to 0.33 mm (0.006" to 0.013")
Weight load type
Movable tag full sensor
occurrence.
Stepping motor (Interfaces with the printer)
2-phase unipolar type stepping motor
W 219 X D 245 X H 300 mm
(W 8.6" X D 9.6" X H 11.8")
3.4 kg (7.5")
Simple fixation by joint plate.
* Can be set by the users.
ST-TG3
TG3 Series Operator Manual