Domain Name System (Dns) Commands - D-Link DXS-3600-16S Manual

Domain Name System (DNS) Commands

17-1 ip domain-lookup
This command is used to enable the domain name look up for the switch itself's application. For example, to ping a
domain name on the switch. Us the no form of this command to disable this function.
ip domain-lookup
no ip domain-lookup
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#ip domain-lookup
DXS-3600-32S(config)#
17-2 ip name-server
This command is used to configure the IP address of the domain name server. Use the no form of this command to
delete the configured domain name server.
ip name-server [vrf <string 1-12>] ip-address
no ip name-server [vrf <string 1-12>] [ip-address]
Parameters
vrf <string 1-12>
ip-address
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#ip name-server 192.168.5.134
DXS-3600-32S(config)#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
None.
By default, this option is disabled.
Global Configuration Mode.
Level: 8
This command enables the domain name resolution function.
This example shows how to enable the DNS domain name resolution function.
Specifies the VRF that the IP reside in. If no VRF name specified, the global instance
will be used.
Specifies the IP address of the domain name server.
None.
Global Configuration Mode.
Level: 8
Add the IP address of the DNS server. Once this command is executed, the
equipment will add a DNS server. When the device cannot obtain the domain name
from a DNS server, it will attempt to send the DNS request to subsequent servers
until it receives a response. Up to 2 DNS servers are supported. You can delete a
DNS server with the ip-address option or all the DNS servers.
This example shows how to set the domain name server 192.168.5.134
227