D-Link DXS-3600-16S Manual page 44

Example
DXS-3600-32S#show expert access-group
Interface tenGigabitEthernet 1/0/2:
expert access-group exp1 in
DXS-3600-32S#
3-23 vlan access-map
This command is used to create a submap. This command will enter into the access-map configuration mode. The no
form of this command deletes the submap.
vlan access-map map_name [map_sn]
no vlan access-map map_name [map_sn]
Parameters
map_name
map_sn
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#vlan access-map vlan-map 20
DXS-3600-32S(config-access-map)#
3-24 match ip / mac address
This command is used to associate an IP ACL or MAC ACL with a specific submap. The no form of this command
removes the configuration.
match ip address {acl_name | acl_id}+8
no match ip address {acl_name | acl_id}+8
match mac address {acl_name | acl_id}+8
no match mac address {acl_name | acl_id}+8
Parameters
acl_name
acl_id
+8
Default
Command Mode
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to display the expert ACL, applied to the interface.
Specifies the name of the hostmap to be configured. The name can be up to 32
characters long.
Specifies the sequence number of the submap.
None.
Global Configuration Mode.
Level: 12
A sequence number will be assigned automatically if the user did not assign it
manually. Automatic assignment of the sequence number starts from 10 and
increases by 10 for every new entry.
This example shows how to create a VLAN access map.
Speicifies the name of the ACL to be configured. The name can be up to 32
characters long.
Specifies the sequence number of the ACL.
Input parameters can be continuously, but not more than 8 times.
None.
Access-map Configuration Mode.
36