Debug Vrrp - D-Link DXS-3600-16S Manual

Example
DXS-3600-32S#show vrrp interface vlan1 group 1
vlan1 – Group 1
State is Master
Virtual IP Address is 10.1.1.1
Virtual MAC Address is 00-00-5E-00-01-01
Advertisement Interval is 1 seconds
Preemption is enabled
Priority is 255
Master Router is 10.1.1.1
DXS-3600-32S#
Display Parameters
Interface
Grp
Pri
Own
Pre
State
Master addr
Group addr

69-8 debug vrrp

This command is used to turn on the VRRP debug function. Use the no form of the command to turn off the VRRP
debug function.
debug vrrp
no debug vrrp
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#debug vrrp
DXS-3600-32S#
69-9 debug vrrp errors
This command is used to turn on the VRRP error prompt debug switch. Use the no form of the command to turn off the
VRRP error prompt debug switch.
debug vrrp errors
no debug vrrp errors
Parameters
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows detailed information about group 1 on interface 'vlan1'.
Description
Interface name the virtual routers belong to.
Group ID, the identifier of virtual router, as specified with the vrrp ip command.
The priority of virtual router, as specified with the vrrp priority command.
"Y" represents IP address owner.
The preempt mode of virtual router, as specified with the vrrp preempt command.
"Y" represents the preempt mode is enabled.
State of this virtual router, which could be Master, Backup or Init.
The IP address of the interface that the Master virtual router belongs to.
The IP address of virtual router, as specified with the vrrp ip command.
None.
By default the VRRP debug is turned off.
Privileged EXEC Mode.
Level: 8. (EI Mode Only Command)
Use this command to turn on or turn off the VRRP debug function.
This example shows how to turn on the VRRP debug function.
None.
638