D-Link DXS-3600-16S Manual page 402

Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#router ospf
DXS-3600-32S(config-router)#redistribute rip metric 5 metric-type 1
DXS-3600-32S(config-router)#
40-22 router ospf
This command is used to enable OSPF and enter the router configuration mode. Use the no form of this command to
disable OSPF.
router ospf [vrf vrf-name]
no router ospf [vrf vrf-name]
Parameters
vrf vrf-name
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
By default route redistribution is disabled.
By default metric-type is 2.
By default no route map is used.
Router Configuration Mode.
Level: 8. (EI Mode Only Command)
External Routes can be redistributed to normal area as type 5 external routes, and
redistributed to NSSA stub area as type 7 external routes by ASBR.
The external route type can be type 1 or type 2. If the redistributed external route is
of type 1, the metric represents the internal metric. If the redistributed external route
is of type 2, the metric represents the external metric. An internal metric will consider
the cost of the route from itself to the redistributing router plus the advertised cost to
reach the destination. An external metric only considers the advertised metric to
reach the destination.
By default, connected and static route will not be re-distributed either.
Use the redistribute or the default-information router configuration commands make
the router becomes an ASBR.
If a metric is not specified, metric will be the value set by default metric command. If
no value specified by default metric, routes redistributed from other protocols will get
20 as the metric value with the following exception. BGP will get 1 as the metric
value.
Note that if the redistricted route is a default route, then the metric is determined by
default-information originate command.
Users can verify the settings by entering the show ip ospf command.
This example shows how to enable redistribution of RIP routes into the OSPF
routing domain and set the metric to 5.
(Optional) Specifies to restart OSPF VRF instance.
By default OSPF is disabled and no OSPF VRF instance is created.
Global Configuration Mode.
Level: 8. (EI Mode Only Command)
394