D-Link DXS-3600-16S Manual page 353

Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface vlan 1
DXS-3600-32S(config-if)#mpls ip
DXS-3600-32S(config-if)#
38-4 mpls static ftn
This command is used to add a static FTN entry. Use no mpls static ftn command to remove the previous configured
static FTN.
mpls static ftn NETWORK-PREFIX/PREFIX-LENGTH out-label LABEL-VALUE nexthop IP-ADDRESS
no mpls static ftn {NETWORK-PREFIX/PREFIX-LENGTH | all}
Parameters
NETWORK-PREFIX/
PREFIX-LENGTH
out-label LABEL-VALUE
nexthop IP-ADDRESS
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#mpls static ftn 172.18.10.0/24 out-label 100 nexthop 110.1.1.2
DXS-3600-32S(config)#
38-5 mpls static l2vc-ftn
This command is used to configure one static VC FTN item. Use the no form of this command to delete the configured
FTN item.
mpls static l2vc-ftn VC-ID IP-ADDRESS out-label LABEL-VALUE
no mpls static l2vc-ftn VC-ID IP-ADDRESS
Parameters
VC-ID
IP-ADDRESS
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Level: 12.
This command only can be applied on Layer 3 VLAN interface. Use the mpls ip
command in the interface configuration mode to enable the MPLS forward on this
interface. For forwarding MPLS labeled packets through an interface, MPLS should
be enabled globally and enabled on the interface.
This example shows how to enable MPLS on interface VLAN 1.
Specifies the FEC of the static FTN.
Specifies the out label of this FEC.
Specifies the next-hop IP address of this FEC.
No static FTN.
Global Configuration Mode.
Level: 3.
Use this command to add a static FTN entry. At ingress LER (Label Edge Router),
the incoming IP packets that are classified to the FEC (Forwarding Equivalence
Class) will be pushed the MPLS label and forwarded to next hop according the FTN
(FEC-to-NHLFE).
This example shows how to configure a static FTN that push label 100 for prefix FEC
172.18.10.0/24.
Specifies the PW (pseudo-wire) service instance ID. The range is 1-4294967295.
Specifies the peer LSR ID.
345