D-Link DXS-3600-16S Manual page 431

shutdown
no shutdown
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#shutdown
DXS-3600-32S(config-if)#exit
DXS-3600-32S(config)#interface range tenGigabitEthernet 1/0/1-1/0/10
DXS-3600-32S(config-if-range)#no shutdown
DXS-3600-32S(config-if-range)#
43-5 description
This command is used to specify the description of the ports.
description WORD
no description
Parameters
WORD
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#description tengigabitethernet1
DXS-3600-32S(config-if)#exit
DXS-3600-32S(config)#interface range tenGigabitEthernet 1/0/1-1/0/10
DXS-3600-32S(config-if-range)#no description
DXS-3600-32S(config-if-range)#
43-6 duplex
This command is used to specify the communication system used.
duplex {full | half | auto}
no duplex
Parameters
full
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
None.
By default, this option is disabled.
Port Configuration Mode.
Level: 15
None.
This example shows how to disable a port.
Specifies to set the description of the port interface.
None.
Port Configuration Mode.
Level: 15
None.
This example shows how to specify the port description.
Specifies that the communication system will be set to full-duplex.
423