D-Link DXS-3600-16S Manual page 133

Display Parameters
Status codes
Origin codes
IP Address/Netmask
Gateway
Metric
LocPrf
Weight
Path
Route Distinguisher
From
In label
Out label
Self Peer
no
default for vrf
VPN route(s)
7-72 show ip bgp aggregate
This command is used to display the aggregate entry in the BGP (Border Gateway Protocol) database.
show ip bgp aggregate [vrf VRF-NAME] [NETWORK-ADDRESS]
Parameters
vrf VRF-NAME
NETWORK-ADDRESS
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Description
Status of the table entry displayed at the beginning of each line. It can be one or
more of the following values:
s—The table entry is suppressed.
d—The table entry is damped.
h—The table entry is damped and has been withdrawn by the neighbor.
*—The table entry is valid.
>—The table entry is the best entry to use for that network.
i—The table entry was learned via an internal BGP (iBGP) session.
Origin of the table entry displayed at the end of each line. It can be one of the
following values:
i—Entry originated from an Interior Gateway Protocol (IGP) and was advertised
with a network router configuration command.
e—Entry originated from an Exterior Gateway Protocol (EGP).
?—Origin of the path is not clear. Usually, this is a router that is redistributed into
BGP from an IGP.
IP prefix with its mask length of the entry.
IP address of the next router that is used when forwarding a packet to the destination
network. An entry of 0.0.0.0 indicates that the router has some non-BGP routes to
this network.
If shown, this is the value of the inter-autonomous system metric. This field is
frequently not used.
Local preference value as set with the set local-preference route-map configuration
command. The default value is 100.
Weight of the route as set via autonomous system filters.
Autonomous system paths to the destination network.
Specify the route distinguisher of the following routes.
Specify the origin of this prefix.
Specify the label which would be assigned to other routes that origin from other PE.
Specify the label which get form other PE neighbor.
Specify that the route is originated from local.
Specify this prefix does not have label of this direction.
Specify the VRF which The route distinguisher is default for.
Specify that the following routes are learned from PEs.
(Optional) Specifies the VRF name. The length of the VRF-NAME is 12 characters.
(Optional) Specifies the network address and the sub-network mask, for example:
120.25.0.0/16
None.
Privileged Mode.
Level: 3. (EI Mode Only Command)
This command is used to display aggregate entries created.
125