D-Link DXS-3600-16S Manual page 623

66-15 show protocol-vlan
This command is used to display the configuration settings of a protocol VLAN. The show protocol-vlan profile
command displays the protocol VLAN list and its protocols. The show protocol-vlan interface command displays the
protocol group binding VLAN of the ports.
show protocol-vlan {profile [PROFILE-ID] | interface [INTERFACE-ID [, | -]]}
Parameters
profile
PROFILE-ID
interface
INTERFACE-ID
,
-
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show protocol-vlan interface tenGigabitEthernet 1/0/1-1/0/3
Interface Profile ID/Binding-VLAN/Priority
--------- ------------------------------------------
TGi1/0/2 10/3000/
DXS-3600-32S#
Example
DXS-3600-32S#show protocol-vlan profile
Profile ID Frame-type
---------- -----------
10 Ethernet2
DXS-3600-32S#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the display protocol group.
(Optional) Specifies the profile ID of the protocol group. If not specified, display all
protocol groups.
Specifies the display protocol VLAN that is associated to interfaces
Specifies the interface to display.
(Optional) Specifies a series of interfaces, or separate a range of interfaces from a
previous range. No space is required before or after the comma.
(Optional) Specifies a range of interfaces. No space is required before or after the
hyphen.
None.
EXEC Mode.
Level: 3
The user can use the show protocol-vlan command to display the current protocol
VLAN status. The user can display the protocol VLAN group list table by using the
show protocol-vlan profile command. The user can display the protocol VLAN
binding of the ports by using the show protocol-vlan interface command.
This example shows how to display the protocol VLAN binding of ports 1-3.
-
This example shows how to display the protocol group settings.
Ether-type
----------------
0x86DD(IPv6)
615